A.3 hayes at command summary – Campbell Scientific COM200 Telephone Modem User Manual
Page 17
Appendix A. Modifying the Non-Volatile Memory
A-3
Example Program 1
*Table 1 Program
01: 1
Execution Interval (seconds)
1: Initiate Telecommunications (P97)
1:
02
RF Modem/9600 Baud
2:
1
Disabled when User Flag 1 is High
3:
20
Seconds Call Time Limit
4:
0
Seconds Before Fast Retry
5:
0
Fast Retries
6:
0
Minutes before Slow Retry
7:
1
Failures Loc [ Failure ]
8:
0
Data Logger ID
2: Extended Parameters (P63)
1:
65
Option ;A
2:
84
Option ;T
3:
83
Option ;S
4:
48
Option ;0
5:
61
Option ;=
6:
51
Option ;3
7:
38
Option ;&
8:
87
Option ;W
3: Extended Parameters (P63)
1:
48
Option ;0
2:
68
Option ;D
3:
84
Option ;T
4:
13
Option
5:
00
Option
6:
00
Option
7:
00
Option
8:
00
Option
A.3 Hayes AT Command Summary
This manual does not attempt to be a primer on the Hayes AT command set.
The commands are, therefore, only summarized below. For most applications,
these commands will not need to be used. Except as noted, all commands
should begin with an “ AT” and end with a carriage return (hit the [Enter]
key). There are no “ O” as in Oscar commands, only “ 0” as in Zero
commands. All commands must be issued as CAPITAL letters.