Chatsworth Products F-Series TeraFrame® HD - Manual (Page 5)

Chatsworth Products Inc. Installation Guide TeraFrame HD 08/27/10
Chatsworth Products Inc. Version 1
CAUTION: Position pallet loaded with cabinet to allow 20 feet of clearance
between the pallet/ramp interface and final stopping point for cabinet to roll
off ramp and come to a complete stop.
1. Check pallet deck height versus ramp. If pallet deck is too low to properly align with
ramp, carefully lift pallet with appropriate equipment (pallet jack, forklift, etc.) and add
spacers on floor under front and rear edges of pallet as required to raise and level the
pallet deck to align with the ramp. .
2. Remove front shipping bracket anchoring cabinet to pallet.
WARNING: Do not remove rear shipping bracket anchoring cabinet to
pallet.
3. Align metal ramp to pallet and bolt the ramp to the pallet.
4. Remove bolts securing rear shipping bracket to the cabinet frame, but do not remove the
bolts securing the rear shipping bracket to the pallet.
WARNING: Do not remove bolts securing rear shipping brace to pallet.
5. Due to extremely heavy load, use a minimum of three individuals to move cabinet
towards ramp and walk adjacent to or behind cabinet.
WARNING: Do not allow anyone in front of cabinet during movement.
6. Once clearance is assured, move cabinet onto ramp and allow it to roll down.
WARNING: Do not attempt to stop cabinet during movement.
7. Once cabinet has stopped rolling, it is OK to maneuver cabinet as required.
CAUTION: It is recommended to move the cabinet with swivel casters at
the rear.