Audiovox K-9 - Manual (Page 2)

P/N 8007132
Page 2 of 10
Rev. B
This manual contains specific instructions on how to install this automotive TV/VCP
floor console. Please read this manual thoroughly before installing the console into
the vehicle.
**WARNING**
In order to maintain a safe mounting system, this console MUST be secured to
the floor of the vehicle according to the instructions contained in this manual.
Failure to do so may result in the console breaking loose in the event of an
accident.
It is unlawful in most jurisdictions for a person to drive a motor vehicle which
is equipped with a television viewer or screen that is located in the motor
vehicle at any point forward of the back of the driver’s seat, or that is visible,
directly or indirectly, to the driver while operating the vehicle. This product
should only be installed to the rear of the driver’s seat where it will not be
visible, directly or indirectly, to the operator of the motor vehicle.
Required tools for installation:
Electric drill
¼” steel drill bit
1/8” steel drill bit
Phillips screwdriver
Socket wrench set with deep-well, 7/16” socket
Box end wrench, size 7/16”
Soldering Iron
Two people are required for installation.
0892105 Bracket Kit 1
8007101 Bracket, Mounting 4
8007105 Screw, Hex #8x3/4 self drilling 20
8007106 Washer, 3/16” 20
8007110 Strap, Open, Nylon 1
8007111 Strap, Loop, Nylon 1
8007125 Bolt, ¼”x1 ½”, Hex
4
8007126 Washer, Fender 5/16” 4
8007128 Nut, Nylon Insert ¼” 4
8007132 Installation Manual 1