Samlex America RC-200 - Manual (Page 3)

SAMLEX AMERICA INC. | 3
SECTION 1: SAFETY
before using this Remote Control, please follow the Safety Instructions given in
the owner’s Manual for the inverter.
SECTION 2 | DESCRIPTION
RC-200 is a wired Remote Control that is compatible with the following series
of Inverters: PST-1500-12, PST-1500-24; and PST-2000-12, PST-2000-24.
It is used to switch oN and switch off the inverter from a remote location. It
also displays the operational status using LCD display and colored LeDs. It is
provided with 5 Metres / 16.5 feet of connecting cable set with RJ-50 Modular
Plugs (10P10C). The conductors of the cable set have crossed-over (rolled-over)
connections on the two RJ-50 plugs.
SECTION 3 | LAYOUT OF CONTROLS, INDICATIONS
& DIMENSIONAL DRAWING
fig. 1 (page 4) shows the layout of controls and indications and dimensional
drawing.
ON/OFF Control
oN/off Push button (1) is used to switch oN and switch off the inverter. every
time the oN/off Push button is pressed, a beep will be heard.
LCD Display
LCD screen (3) is used to display the following 6 output parameters in a se-
quential loop as given below.
The screen changes to show the successive parameter in a sequential
manner every time the “Display Push button” (2) is pressed (Sequence is:
Screen1-2-3-4-5-6-1-2-3…)
1. AC output voltage in Volts, V
2. AC output current in Amps, A
3. AC output frequency in Hertz, Hz
4. Active AC output power in Watts, W - The display is limited to a
range of 2.5W - 3500W
5. Apparent output Power in Volt Amps, VA
6. Power factor, Pf
When the inverter is switched oN using the oN/off Push button (1), the LCD
screen displays information as follows:
• It takes 2 to 6 sec for booting / initialization. During this time, all the above
6 parameters will be displayed as “0”
• If the load is > 2.5W, all the above 6 parameters will be available for display after
end of booting / initialization period
• If the AC output power is less than 2.5W, parameters “AC output current in A”,
“Active AC output power in Watts, W”, “Apparent output AC Power in Volt