Flytec 3005 - Manual (Page 2)

Seite 2 von 2
consult a specialist).
Descent tone / descent alarm: A continuous falling tone frequency de pendent on descent with a timbre dependent on scale (ASI: Acoustic Scale
Indication ).
Can be switched on or off by pressing the descent tone key (8). On switch ing on the descent tone/alarm and pressing the key, a segment will appear in the
descent sector of the vario display to indicate the current response point. When the descent tone/alarm is switched off, pressing the key will not produce
a display.
The descent tone/alarm will only, sound when the vario acoustic facility is switched on.
When the descent tone key ( 8 ) is pressed for approx. 3 seconds, the unit moves into the adjustment mode for descent tone/alarm (see Setting mo de).
The response point can be adjusted within the fi rst sector of the scale.
Speed indicator: The vane-wheel sensor is connected to the socket (12) on the right-hand side of the unit. The indicator replaces the digital vario display
( 3 ), which is shown by the indicator above the display. When the vane-wheel sensor is connected, the display switch (13) can be used to toggle between
the digital vario display and the speed indicator.
Peak value memory: Pressing the MEMO key (10) will display the peak values (max. absolute altitude 2 and maximum ascent) of the current fl ight (F0).
Pressing the reset key UP (6) or DOWN (7) will invoke the peak values of the last four fl ights (F1, F2, F3 and F4), with fl ight 4 (F4) the least recent fl ight.
Flight data is saved automatically when the unit is switched off (condition: the unit must have been switched on for 3 minutes and there must have been
a clear difference in altitude).
Memories F1 to F4 are updated and the data of the least recent fl ight is deleted.
Battery change: Unscrew the battery compartment. Use two 1.5 V batte ries. Please do well observe the polarity (+/-). After the battery change, switch on
the instrument and control the display. Now switch off the instrument again. lf the instrument stays for more than one minute without batteries the MEMO
will be deleted.
Water damage: Open the unit immediately. lf salt water has entered the unit, rinse it thoroughly (the printed circuit board, in particular) with hand-hot fresh
water. Allow the unit to dry as well as possible, preferable in the sun. lf this is not possible, the unit must be placed on a piece of wood in an oven. Allow
the unit to dry off for one or two hours as required, at a temperature of approx. 50ºC. Leave the oven door open slightly to allow any moisture to escape!
N.B. Never put the unit in a microwave oven!
Attachment: Clip or special attachment for hangglider (fi t to the rear of the unit). The clip can be unscrewed, twisted 90º and refi tted.
Adjusting the security cord: Open the unit, cut the cord to the required length and knot it well. Tighten the cord from the outside and screw the unit
together again.
Servicing, repairs: Return the unit to your nearest FLYTEC service agent.
FLYTEC AG
Ebenaustrasse 8a, CH-6048 Horw
Telefon: 041 / 340 34 24
Telefax: 041 / 340 54 24