Rmc 7182 – Acnodes RMC 7182 User Manual

Page 51

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

RMC 7182

1U Rackmount System

Onboard Power LED

An onboard Power LED header is located at
JLED. This header con- nects to the control panel
header (JF1) to indicate the status of system
power. See the table on the right for pin definitions.

Power Supply SMBus Connector

A Power SMB header is located at SMB_PS1.
Connect the appropriate cable here to utilize
SMB on your system. See the table on the right
for pin definitions.

Universal Serial Bus (USB)

There are two Universal Serial Bus additional six
USB headers are in- cluded on the board, which
may be used for front side access (cables not
included). USB 6 and USB 7 are "Type A" connec-
tors. See the table on the right for pin definitions.

SGPIO Headers
The SGPIO (Serial General Purpose Input/Output)
headers are used to communicate with an enclo-
sure man- agement chip on the backplane. The T-
SGPIO headers are for SATA and the 3-SGPIO
headers are for SAS configurations. See the table
on the right for pin definitions.