Siemens TS20XTRM2 - Manual (Page 18)

18
SIEMENS
ENGLISH
F
Rinsing the iron steam
chamber
Caution! Risk of burns!
This procedure helps to remove scale particles
out of the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when
after a long period of use with very hard water,
scale particles start to come out of the soleplate.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (15) of the iron to
the “min” position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main
power switch (13) to the “I” position.
e) Wait until the “steam ready” indicator lamp (9)
lights up.
f) If the steam station has steam regulator (11*),
set it to the maximum position .
g) Hold the iron over the sink or a container to
collect the water.
h) Press the steam release button (16) and gently
shake the iron. Boiling water and steam will
come out, carrying scale and or deposits that
might be there. This could take approximately 5
minutes.
i) Set the temperature selector (15) of the iron to
the “max” position, without pressing the steam
release button (16). The water in the steam
chamber will start evaporating. Wait until all the
water inside the chamber has been evaporated.
j) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
Cleaning &
Maintenance
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale,
clean it with a damp cloth.
4. Never use abrasive products or solvents.
E
“Calc‘n clean”
Cleaning the Boiler
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is cold and unplugged
for more than 2 hours, and that the water tank
(1) is empty.
2. Place your appliance on the edge of your
kitchen sink.
3. Remove the plastic cover located on the
bottom of the appliance by turning it to the
position.
4. Unscrew the boiler drainage plug using a coin.
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water
6. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
To obtain the best result, we recommend that
this operation is done twice.
Important: before re-closing, make sure no
water remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin.
8. Insert and close the plastic cover by turning it
to the position.
Automatic clean warning
(depending on model)
Pilot light (12*) will flash indicating that boiler
must be rinsed. To do this, follow the procedure
described in the section above.
To reset “Calc‘n clean” pilot light and counter,
switch the station off twice, keeping it off
during at least 30 seconds each time.
(on → 30s off → on → 30s off → on)