Siemens TS20XTRM2 - Manual (Page 17)

17
SIEMENS
ENGLISH
“Pulse steam”
function
(Model dependent)
This appliance has a special function for tackling
difficult creases.
When the steam release button is activated, the
steam generator will give three powerful shots of
steam so that the steam reaches even deeper
into the fabrics.
1. Set the temperature selector (15) on “• • •”
2. Press the steam release button (16) on the bottom
of the handle two times shortly (double-click)
or (model dependent)
Shortly press the steam release button (17*) on
the top of the handle.
Remark :
– It is possible to stop the shots of steam by
pressing the steam button shortly again.
– Some water drops may appear when you use
the “Pulse steam” or the function for the first
time. The water drops will disappear after you
have used the function for some time.
“Intelligent steam” function
(Model dependent)
This system has intelligent steam control, which,
after releasing the steam release button (16),
provides a small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once again.
Ironing without steam
Begin ironing but without pressing the steam
release button.
C
Vertical steam
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
1. Set the temperature control to the “•••” or “max”
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the
steam release button.
Energy saving “eco”
button
(Model dependent)
If the “Energy saving” button (8*) is switched on,
the energy consumption of the appliance will be
reduced, by means of automatic reduction of
electricity and water consumption. A good ironing
result can be obtained for most of the garments.
Use the normal energy setting only for thick and
highly wrinkled fabrics.
Note: If you work with the “Energy saving”
function, the variable steam regulation and
temperature regulation can still be used as
recommended.
Auto shut-off
(Model dependent)
If during ironing, the steam release button
(16-17*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The “auto shut-off” pilot lamp (9) will flash when
auto shut-off has been activated.
To switch the steam station back on, press the
steam release button again.
D
Fabric protection
soleplate cover
(Model dependent)
The fabric-protection soleplate cover is used for
steam-ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from the customer service or specialist
shops:
Accessory code
(After-sales)
Name of accessory
(Specialist outlets)
571510 TZ20450