Siemens DO05755K User Manual
Page 17
17
en
Oversink appliances DO05805, DO05855,
DO3185D5 and DO05805CH
Align the appliance on the wall and use the three indents
■
(top, left and right on the appliance) to apply markings
(F).
Connect the markings to a pattern of crossed lines with a
■
spirit level (G1 and G2).
Place the installation bracket on top at the point of inter-
■
section of the drawn lines and mark the position for the
holes (H).
Drill the holes and insert wall plugs (
■
I1).
Attach the installation bracket (notch at top) to the wall
■
using the screws (I2).
Exchanging appliances
When replacing an old Siemens small water heater with this
new appliance, the existing drill holes with wall plugs can
be used. Please note that the new appliance is approx. 2 cm
higher.
Turn the installation bracket around and attach to the wall
■
with the notches at the bottom (J).
I1
I2
2x
2x
H
G2
G1
3x
3x
F
180°
J