Siemens TE809F01DE - Manual (Page 51)

47
en
Cleaning the milk system
Duration: approx. 1 minute
Short rinse milk system ▶ start
The milk system 10 can be pre-cleaned
automatically.
● Press the à button 3.
Short rinse milk system ▶ start
● Press the start button 8.
Place empty glass under milk frother and
place suction pipe in glass ▶ start
● Place an empty glass under the milk
system 10 and put the end of the pipe
10d in the glass.
● Press the start button 8. The milk system
is cleaned automatically.
● Now empty the glass and clean the
suction pipe 10d.
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Descaling
Duration: approx. 30 minutes.
Descale ▶ start
The start button 8 flashes while the different
descaling processes are running.
The figures on the top right indicate the
progress of the programme.
Important: If there is a water filter 29 in
the water tank 11, it needs to be removed
before the service programme is run.
● Press the à button 3.
Descale ▶ start
● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Place 1 l container under milk frother
Place suction pipe in container ▶ start
● Place a container with 1 litre capacity
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8.
Remove water filter ▶ start
Info: If the water filter 29 is activated, the
display will prompt you to remove the filter
29, then press the start button 8 again.