Siemens TE809F01DE - Manual (Page 44)

40
en
The appliance is ready for use again.
Info: Rinsing the filter 29 simultaneously
activates the setting for the “change filter”
display.
You can find detailed information about the
water filter in the enclosed filter instructions.
The filter 29 is no longer effective when the
Service - change filter display appears, or at
the latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Water filters are available from retail outlets
or from customer services (see the section
“Accessories”).
If no new filter 29 is used, turn the Water
filter setting to no.
Info: If the appliance has not been used
for a prolonged period (for example, when
you are on vacation), the existing filter 29
should be rinsed before the appliance is
used again. To do this, simply dispense a
cup of hot water.
Transportation lock
● To avoid damage caused by frost during
transport and storage, the appliance must
be completely emptied first.
Info: The appliance must be ready for use
and the water tank 11 filled.
● Press the start button 8. The appliance
automatically empties the pipe system
and switches off.
● Empty the water tank 11 and the
drip tray 23.
Factory reset
You can cancel your own settings and reset
the factory settings.
● To activate the factory settings, press the
start button 8.
Info: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched
off fully.
● Hold down the selection buttons < and
> 4 and the on/off switch 1 O / I at the
same time for at least 5 seconds. Press
the start button 8. The factory settings
are now reactivated.