Matrix Orbital VK162-12 Legacy - Manual (Page 27)

¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"Vb¢iqpriseHfg¨£¨13QFRG0¡1DQBt3$ u5¥E15u3Q¡1"¥Ev37D$B£BU5718
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%791%%ueSfg¨£¨13$FUG0¡1DQBw3Q u5¥E15130¡1"¥ExT¢5¢CFu"y%)€0&
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbQ($2)eHf¨¨‚ƒ!¢a£¡1"uG„¡¢D 30E¢"£5¥¡1"
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbQ($‚)eHf¨¨7¡ u"†3QFRG0¡1DQB‡3Q 15¥E15u30¡¢"¥E
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbQ($‚)eHf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbQ($2)eHf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%ueSf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%ueSf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%ueSf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%ueSf
¡9¥Y)5¥E£¡ PG7"7187`¢a£¡1"VbP%791%%ueSfg¨£¨¥8)GQ¤)C57av3QFUG0¡¢DQB‡3Q u5¥E¢5u30¡1"¥Ex%
6 Miscellaneous Commands
The commands listed in this chapter don’t readily fit in any of the other categories, or are used in more
than one category.
Some commands, marked with an “R”, may be ’remembered’ to set new defaults that will be in effect
each time the unit is powered on.
6.1 Command List
This chapter deals with command functions.
6.1.1 Remember
This command allows a number of settings, such as cursor state, backlight, etc. to automatically be stored
to non-volatile memory so they become new defaults. The command should only be used when required for
two reasons;
1. Writing to non-volatile memory is time consuming and slows down the operation of the display.
2. Non-volatile memory has a ’write limit’ and may only be changed approximately 100,000 times.
Commands which may be used with the ’remember’ function are marked with an "R" in the "Default" column
in the command tables. The example shows the procedure to set “Auto scroll ON” as the default condition.
Commands are shown in both decimal and hex in this example;
Matrix Orbital VK162-12 23