Matrix Orbital LK402-25 Legacy - Manual (Page 32)

Description This command turns ON general purpose output [num]. The standard
GPO’s on the LK402-25 output 20mA of current at 5V.
NOTE ON means the output is pulled HIGH.
Remembered Yes
7.4 Set Startup GPO state
Syntax Hexadecimal 0xFE 0xC3 [Num] [state]
Decimal 254 195 [Num] [state]
Parameters Parameter Length Description
Num 1 GPO number.
state 1 Startup state (0: Off, 1: On)
Description This command will set the startup state for the GPO on the next power
up. A value of one will cause the GPO to be off on the next startup
while a value of one will cause the GPO to be on.
NOTE This command does not affect the current state of the GPO.
Remembered Always
8 Dallas 1-Wire
8.1 Introduction
Another convenient feature of the LK402-25 is that it provides a Dallas 1-wire interface in order to
readily communicate with up to thirty two 1-wire devices on a single bus. 1-wire communication is begun
by discovering the address of the device that you wish to communicate with. To do this you must send the
“Search for a 1-Wire Device’ command. After you have established the address of the device that you wish
to communicate with, you may begin a transaction with the device
8.2 Search for a 1-Wire Device
Syntax Hexadecimal 0xFE 0xC8 0x2
Decimal 254 200 2
Matrix Orbital LK402-25 28