Aalborg XFM Digital User Manual
Page 38
35
UAR
T
Error Codes:
1
-
Not Supported Command or Back Door is not enabled.
2
-
Wrong # of Arguments.
3
-
Address is Out of Range (MR or MW commands).
4
-
Wrong # of the characters in the Argument.
5
-
Attempt to Alter Write Protected Area in the EEPROM.
6
-
Proper Command or Argument is not found.
7
-
Wrong value of the Argument.
8
-
Reser
ved.
9
-
Manufacture specific info EE KEY (wrong key or key is disabled).
COMMAND
NAME
DESCRIPTION
No.
COMMAND SYNT
A
X
Command
Argument 1
Argument 2
Argument 3
Argument 4
Response
Maintenance
Ti
m
er
Hours since last time unit
was calibrated.
11
C
R
(read timer)
alue> (in Hours) C (set timer to zero) CC Full Scale Returns the full scale rated flow in L/min. (Note: This term is not multiplied by the current K factor) 12 E alue> (in L/min) LCD Back Light LCD Back Light control (0-100.0%) 0 - off 100 - Maximum Intensity 13 B 0 to 100% B: where: Counts (0 – 4095) B: alue> where: V alue (0 – 100.0) No Argument Read EEPROM Memor y Reads the value in the specified memor y location. 14 MR 0000 to999 (T able Index) Write EEPROM Memor y Writes the specified value to the specified memor y location. Use Carefully , can cause unit to malfunction. (Note: Some addresses are write protected!) 15 MW 0000 to 999 (T able Index) V alue MW ,XXX, alue> where: XXX=T able Index