Legacy Classic Furniture Nursery Stage 4 Bed Rails 2830-8930 - Manual (Page 3)

Assembly Instruction 2830-8900 CRIB MADISON
Page 3 of 6
HARDWARE ENCLOSED:
(F) Hex bolt screws: M6 x 38 – 8 pcs
(G) Bottom head bolt M6 x 17 – 4 pcs
(H) Lock washer M6 – 12 pcs (I) Flat washer M6– 12 pcs
NOTE: Store all hardware out of child’s reach.
TOOLS REQUIRED:
(J) Hex Allen Wrench with Ball tip -1 pc (included) Phillips Screwdriver (not included)
PRE- ASSEMBLY:
 Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work
surface, as this will avoid damaging parts during assembly. The shipping box provides an ideal work
surface.
 Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
 Use the parts and hardware lists above to identify and separate each of the pieces included.
 The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
 The use of power tools for assembly is not recommended. Power tools can damage hardware or split
wood.
ASSEMBLY INSTRUCTIONS:
1. Remove the assembly instructions from the envelope attached to the Crib and review. Keep them handy
for referring to the part and hardware descriptions .
2. Assemble the Left Side Gate (A) and Right Side Gate (B) to the Mattress Metal Base Brackets (C) with 4
Bolts (G), Lock washer (H), Flat washer (I), using the Hex Allen Wrench (J). Adjust the brackets of the
Mattress Metal Base (C) to fit the hole of Side Gate when assembling (See Fig 1)
.
NOTE: The Mattress support base may be at the highest level when the child is born. It must be at the
lowest level by the time the child can stand up.