Clary SP U-MPL - Manual (Page 21)

Page 21
SERVICE AND REPAIR
This SP-MPL Rackmount is backed by one of the finest customer service teams assembled.
Write or call them at any time to obtain information about your unit.
Clary Corporation
150 E. Huntington Dr.
Monrovia, CA 91016
626-359-4486
800-551-6111
[email protected]
If a problem should occur, it is important that you obtain a Return Material Authorization (RMA)
number from the Service Department to process any unit returned to the factory. In consulting
the factory, always have the unit model number and serial number at hand. This information is
located on the identification label on the left side and is essential in retrieving your units
performance and history record.
The RMA number issued to you should appear on the outside of the carton, if the unit is returned,
or on any correspondence regarding your unit. When shipping a unit back to the factory, try to
use the original packing container and shipping materials. Shipping materials are available
through the Service Department if the original container is unobtainable. The Service
Department cannot take responsibility for any unit damaged in return shipment. All units must be
returned prepaid to:
CLARY SERVICE DEPT.
150 E. Huntington Dr.
Monrovia, CA 91016
FCC CONSIDERATIONS
This equipment generates and uses radio frequency energy and if not installed and used properly in strict
accordance with the manufacturer's instructions, may cause interference to radio and television reception. The
unit in this manual has been tested and found to comply with the limits for a Class A computing device in
accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide
reasonable protection against such interference in a commercial installation. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause interference to radio and
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the UPS with respect to the receiver.
• Move the UPS away from the receiver.
• Plug the UPS into a different outlet so that the UPS and receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared by the Federal Communications Commission
helpful:
"How To Identify and Resolve Radio-TV Interference Problems"
This booklet is available from the U.S. Government Printing Office,
Washington, DC 20402, Stock No. 004000003454.