Clary S1500-601 - Manual (Page 3)

T H E C O N T I N U O U S P O W E R C O M P A N Y
Page 3
INTRODUCTION
ongratulations! You have selected the highest
quality protection for your continuous power
needs. This unit offers a quiet and compact
package with superior performance you can
depend on. You now own a S Series Continuous Power
System (CPS) which is an all Digital Technology product
manufactured by
Clary Corporation, the first name in
uninterruptible power system (UPS) reliability. The S
designation denotes a custom configuration offshoot
from the standard DT Series. This means the addition of
an input isolation transformer and a medical grade
duplex output receptacle. The Continuous Power
System is the highest order in the hierarchy of UPS
products. When power problems occur, there can be no
compromising the reliability of your power solution. The
S Series Continuous Power System is your complete
power solution.
This Users Manual is provided with your new
S Series unit. It will enhance your understanding of the
product and its functions. Read this handbook carefully
in the order it is presented prior to operating your unit.
This will save you time and effort in your installation and
application. The illustrations will also familiarize you with
this unit’s operating modes and indications. Always
operate the unit within the guidelines and specifications
given to maximize the unit's efficiency and lifetime. Also,
your understanding of the product is essential in
providing you years of service for your continuous power
requirements.
This unit has been manufactured and tested to meet
specific safety standards. It meets UL and FCC
requirements and complies with safety performance
standards.
INDICATIONS FOR USE
The S Series Continuous Power System is
manufactured by Clary Corporation. This product is not
intended for providing power to life support equipment.
Product not intended for use other than as specified in
this document.
DISCLAIMER
Clary Corporation accepts responsibility for the safety,
reliability and performance of this device only if
operational procedures, proper maintenance and repairs
are performed by appropriately qualified persons working
in accordance with the directions presented. Any and all
equipment modifications must be authorized in writing by
Clary Corporation and executed by appropriately
assigned, qualified personnel. The electrical installation
at the site must comply with all applicable local electrical
codes and IEC requirements.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important safety instructions that
should be followed during installation and maintenance
of the UPS and batteries. Be aware of the following
symbols and their meaning as they appear throughout
the manual:
Consult the accompanying documents
prior to operating the equipment to
ensure safe operation.
This device requires an alternating
current power source.
Conductors carrying high voltage are
nearby and could be hazardous if
contacted.
Chassis earth (ground) location on the
device
FCC- Federal Communications Commission
This equipment generates and uses radio frequency energy
and if not installed and used properly in strict accordance with
the manufacturer's instructions, may cause interference to radio
and television reception. All units in this manual have been
tested and found to comply with the limits for a Class A
computing device in accordance with the specifications in
Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a
commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference to radio and television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient the receiving antenna.
Relocate the UPS with respect to the receiver.
Move the UPS away from the receiver.
Plug the UPS into a different outlet so that the UPS and
receiver are on different branch circuits.
If necessary, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared
by the Federal Communications Commission helpful:
"How To Identify and Resolve Radio-TV Interference Problems"
This booklet is available from the U.S. Government Printing
Office, Washington, DC 20402, Stock No. 004000003454.
C
!
∼