Wagner Project Sprayer - Manual (Page 9)

9 English
Title Spraying Technique
1. Keep your arm moving at constant speed and keep the
sprayer at a constant distance from the surface. The
sprayer should be triggered at the beginning of the
stroke and released at the end of the stroke.
2. Keep the sprayer at right angles to the surface. This
means moving your entire arm back and forth rather
than just flexing your wrist.
never tip the sprayer at more than a 45º angle
when spraying overhead. Material could get into
the motor housing and cause an electric shock.
IMPORTanT: If material is leaking from the threads of the
spray tip, turn off the sprayer immediately or the sprayer
could be damaged. The sprayer will leak from behind the
spray tip if the atomizer valve is not seated properly. If
you notice material leaking from this area:
Keep stroke
even
End
stroke
Start
stroke
Pull
trigger
Release
trigger
Move steadily
Aproximately
10 to 14 inches
Heavy Coat
Do not flex
wrist while
spraying.
Light Coat Light Coat
3. Unplug the sprayer immediately. Remove the spray tip
by turning it counterclockwise.
5. Put the atomizer valve back in place, making sure it can
seat properly without any obstruction.
4. Remove the atomizer valve and see if it needs to be
cleaned or replaced (see page 15). Also check the
pump housing opening for any dirt or other obstruction
and clean if necessary.
6. Thread on the spray tip by turning it clockwise and
tighten firmly by hand.