Wagner FLEXiO 590 Sprayer - Manual (Page 13)

English
© Wagner Spray Tech - All Rights Reserved 13
Cleanup (continued)
Cleaning the nozzle
To Clean the Nozzle:
1. Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the
nozzle from the turbine. Wipe the exterior of the cup and
nozzle until clean.
2. iSpray nozzle only -
a. Remove the adjustment ring (a) carefully from the
connecting nut (b). Loosen the connecting nut.
b. Remove the parts as shown. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
To reassemble, see the instructions on the next page.
3. Detail Finish nozzle only -
a. Unscrew the nut and remove the air cap and nozzle.
b. Remove the parts as shown. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
Reassemble all parts when clean* (see “Nozzle Seal”).
4. Clean the air vent (c) on the suction tube with a soft
bristled cleaning brush.
5. Clean the rear of the nozzle (d) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly to
lubricate the O-ring (e).
(c) (d)
(e)
2b
4 5
3b 3a
(a)
(b)
2a
1
* nozzle seal
It is important that the nozzle seal
inside the nozzle be re-installed
properly. Make sure the cup side of the
seal (the side with the groove) is facing
out towards the front of the nozzle.
Groove