Altinex MT104-107 - Manual (Page 12)

MULTI-TASKER
11
Ui = unit number (i = # from 0-9)
Example:
To group cards #1, 2, and 3 as group 5 of unit
#1, send the command [WRC1C2C3G5U1] .
After executing this command, cards 1, 2 and 3
will be grouped together as group 5 of unit 1.
12. [CLR]
This command clears the members for a single
group or for all nine groups.
Command Format: [CLRGkUi]
Gk = group number (k = # from 1-9)
Ui
= unit number (i = # from 0-9)
Example:
1) To clear group #1, send the [CLRG1U1]
command. This command clears the
members for the specified group only.
2) To clear all groups of unit 1, send the
[CLRG [U1] command.
13. [G]
This command is used to request group data.
With the command, the user can identify which
input or output of a particular group is on.
Command Format: [GkUi]
Gk = group number (k = # from 1-9)
Ui
= unit number (i = # from 0-9)
Example:
In unit ID 0, if group 1 has DA Cards with
outputs 1 and 2 on, while group 2 has SW
Cards with input 2 on:
[G1]: will return feedback as ON12 G1U0.
[G2]: will return feedback as ON2 G2U0.
14. [RD]
This command displays the members in each
group.
Command Format: [RDGkUi]
Gk = Group number (k = # from 1-9)
Ui
= Unit ID (i = # from 0-9)
Example:
The cards in slots 1, 2 and 19 are part of group
5 in unit 1. Read the member data for group 5
of unit 1, by sending the command [RDG5U1].
The system will return feedback as follows:
C1C2C19 G5U1
C1 = Card in Slot 1
C2 = Card in Slot 2
C19 = Card in slot 19
G5
= Group 5
U1 = Unit ID 1
15. [CLM]
This command removes the members in a
group and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-9)
Ui
= Unit ID (i = # from 0-9)
Example:
Group 5 of Unit 1 contains the cards in slots 1,
2 and 19. Read the member data for group 5
of unit 1, by sending the command [RDG5U1]:
C1C2C19 G5U1.
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
NONE G5U1
7.3 SUMMARY OF COMMANDS
1) [VER] Receives software version
2) [Ci] Receives status of the card
3) [CiS] Saves card configuration
4) [ON] Turns on one or more outputs for
a single card or a group of cards
5) [OFF] Turns off one or more outputs for
a single card or a group of cards
6) […S] Save the command configuration
7) […F] Provides feedback upon sending