Wagner Control Spray Double Duty - Manual (Page 9)

Troubleshooting
9 English
Problem A: Little or no material flow
Cause Solution
1. Nozzle clogged. Clean.
2. Suction tube clogged. Clean.
3. Material volume setting turned too low (-). Increase volume setting (+).
4. Suction tube loose. Insert.
5. No pressure build up in container. Tighten container.
6. Air filter clogged. Change.
Problem B: Material leaking
Cause Solution
1. Nozzle loose. Tighten.
2. Nozzle worn. Replace.
3. Nozzle seal worn. Replace.
4. Material build-up on air cap and nozzle Clean.
Problem C: Atomization is too coarse
Cause Solution
1. Viscosity of material too high. Thin.
2. Material volume too large. Decrease volume setting (-).
3. Material volume setting too high (+). Decrease volume setting (-).
4. Pressure setting too low. Increase pressure setting (+).
5. Nozzle clogged. Clean.
6. Air filter clogged. Change.
7. Too little pressure build-up in container. Tighten container.
Problem D: Spray jet pulsates
Cause Solution
1. Material in container running out. Refill.
2. Air filter clogged. Change.
Problem E: Pattern runs or sags
Cause Solution
1. Applying too much material.
Adjust material flow or
increase movement of spray
gun.
Problem F: Too much overspray
Cause Solution
1. Gun too far from spray object. Reduce distance.
2. Too much material applied. Decrease volume setting (-).
Problem G: Pattern is very light and splotchy
Cause Solution
1. Moving the spray gun too fast.
Adjust material flow or
decrease movement of spray
gun.
Have you tried the recommendations above and are
still having problems? In the United States, to speak to
a customer service representative, call our Technical
Service at 1-800-328-8251 Monday through Friday
between 8:00 AM and 4:30 PM Central time.
Product Registration
Register your product online at www.wagnerspraytech.com.
Proper registration will serve as proof of purchase in the
event your original receipt becomes misplaced or lost.