MagTek USB KB SURESWIPE & USB KB SWIPE READER - Manual (Page 42)

USB Keyboard Emulation Swipe Reader
34
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Note
This property only applies to swipe readers, not the SureSwipe readers.
ES TK2 PROPERTY
Property ID: 0x18
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0xFF (use ES property)
Description: This character is sent as the end sentinel for track 2 with any format except
JIS type 2. If the value is 0 no character is sent. If the value is in the range 1
– 127 then the equivalent ASCII character will be sent. If the value is 0xFF
then the value of the ES property will be used instead of this property. This
property was not present until firmware revision with software ID
21042812H01.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Note
This property only applies to swipe readers, not the SureSwipe readers.
ES TK3 PROPERTY
Property ID: 0x19
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0xFF (use ES property)
Description: This character is sent as the end sentinel for track 3 with any format. If the
value is 0 no character is sent. If the value is in the range 1 – 127 then the
equivalent ASCII character will be sent. If the value is 0xFF then the value of
the ES property will be used instead of this property. This property was not
present until firmware revision with software ID 21042812H01.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.