Section 1. features and specifications, Configurations, Features – MagTek SWIPE & PARK MT User Manual
Page 7: Applicable documents, Ction 1. features and specifications

1
SECTION 1. FEATURES AND SPECIFICATIONS
The Swipe & Park MT Hybrid Reader supports both mag-stripe and smart card technologies.
For mag-stripe cards, the unit reads tracks 1 and 2, or tracks 1, 2, and 3. For smart cards, the unit
supports ICC 8-pin contacts for ISO smart cards.
CONFIGURATIONS
Configurations are listed in Table 1-1.
Table 1-1. Configuration
Part Number
Head
Head Position*
Tracks
Head Connector
21155003 Single
Head
Down/Left
1,2,3
J1
21155004 Single
Head
Down/Left 1,2
J1
*
The magnetic stripe is inserted in the same orientation as the head position; for
example, head down/left means magnetic stripe down or to the left.
FEATURES
Features of the Swipe & Park Hybrid Reader are as follows:
•
Unibody chassis that consists of a magnetic swipe path inline with a smart card reader
section
•
Provides for mounting a dual or triple track magnetic read head in butterfly configuration
•
Contains an 8-contact smart card block in ISO location
•
Smooth swipe operation with minimal interference or obstruction to the user
•
Mechanical detent keeps the card from sliding away from smart card contacts
•
Proper clearance provided for bowed, warped, and embossed cards
•
Rugged design for installation in harsh and high traffic environments
APPLICABLE DOCUMENTS
Documents applicable to the Swipe & Park Hybrid Reader are as follows:
ISO 7816-1, -2, -3
Identification Cards – Integrated circuits with contacts
ISO 7811-2, -3, -4, -5, -6
Identification Cards – Magstripe cards tracks 1-3
ISO 7810
Identification Cards – Physical Specifications
99821002
MagTek Reader Design Kit
99875148
I/O Interface for TTL Magnetic Swipe Readers, Technical
Reference Manual