MagTek IntelliStripe65 99875141 - Manual (Page 9)

1
SECTION 1. FEATURES AND SPECIFICATIONS
The IntelliStripe 65
TM
Insertion Reader, shown in Figure 1-1, performs the following major
functions:
•
Reads magnetic stripe cards
•
Communicates with ISO smart cards and many popular memory cards
•
Supports one on-board SAM (Security Access Module)
The Reader communicates to a host using an RS-232 or USB interface with a defined protocol
and command set. The Reader has an industry standard mechanical footprint. The IntelliStripe
65 is designed for self-service applications such as pay telephones, vending machines, kiosks,
and fuel pumps.
CONFIGURATIONS
Part numbers for the basic configurations are as follows:
21165003
Single Head Unit, Mag Head position opposite Smart Card Contacts
21165004 Dual Head Unit, Mag Head positions both sides
Both configurations have the following options: Chassis Mount Front/Side, 8 Smart Card
Contacts, Gate Assembly, Card Latch with Release, 3 Tracks on the Mag-Stripe, Plastic Bezel,
Card Present Switch.
For custom configurations, see Appendix A, Options, or contact your MagTek sales rep or the
factory.
ACCESSORIES
Other part numbers that may be shipped with the unit are as follows:
•
RS232 / Power cable
− 6 foot, IntelliStripe 65 host port to 9-pin D female RS232 and 2.5mm
power jack, part number 16051408
•
USB / Power cable – 6 foot, IntelliStripe 65 host port to USB-A and 2.5 mm power jack, part
number 16051425
•
Power Supply – Autoranging 100V-250V, regulated, 12VDC, 2.5mm plug, part number
64300080. Requires adapter to mate with power outlet; use Adapter/Power Cord part
number 71100001 for North American applications.
•
Power Outlet Adapter/Cord, part number 71100001, for North American applications (must
be used with part number 64300080)
•
Drivers, MCP, CD, part number 30037473 (or 99510016 from MagTek.com)