MagTek IntelliStripe65 99875141 - Manual (Page 27)

19
APPENDIX B. BEZEL CONFIGURATION AND MOUNTING
Three bezel configurations are described in this appendix: the International and the North
American Plastic Bezels and the International Metal Bezel. The International Bezels are slightly
larger than the North American Bezel and require a larger panel opening for installation. The
International Bezels are suited to applications requiring metric screws and the North American
Bezel to imperial screws. From the drawings in this section, the user may design a bezel for
different requirements.
INTERNATIONAL PLASTIC BEZEL MOUNTING
The International Plastic Bezel (P/N 21161202) is attached to the unit by four screws (Mounting
inserts M3.5 x 5 Minimum Deep). The four screws are inserted into the front flange slots to
retain the unit to the bezel. Figure B-1 shows the position and the dimensions of the flanges.
Figure B-2 shows the orientation and dimensions of the bezel and recommended dimensions for
the panel opening. Four screws that mount the Bezel to the panel are also M3.5. The length of
the screws depends on the panel thickness, washers, and spacers used in mounting the panel.
Figure B-1. Flanges for International Bezel Mounting