MagTek MCP - Manual (Page 20)

MCP Serial Transport Protocol
14
Reset Device Command
Command Code: 1 (0001)
S-frame Type: Request/Response
Request PCB: 91 (Hex)
Response PCB: A1 (hex)
Description:
This command requests a device to reset itself to its power up state. The device should reset
itself only after it sends the response. The device will not be able to communicate while it is
resetting itself. After the device is reset, the transport will have to reestablish communications
with the device.
Request Data: None
Response Data:
Result Code
Result Codes:
Success = 00 (Hex)
The command completed successfully.
Failure = 01 (Hex)
The command failed.
Unsupported = 02 (Hex)
The command is not supported.