MagTek MODEL MT-85 - Manual (Page 18)

MT-85 RS-232 Reader/Encoder
12
Dump (D)
The "D" command will dump its internal configuration.
Request:
1 2 3 4 5
D *
*BCC is ignored in this command, even if enabled.
Response:
1 2 3 4 5 6 7 8-63 64 65
44H x x x [Y] Not used - Reserved
for future use. {BCC}
(opt)
Locations 4-6 indicate which tracks are enabled. Enabled tracks contain the value 44H; disabled
tracks are 00Hex; location 4 is Track 1, location 5 is Track 2, and location 6 is Track 3. The
communication byte [Y] in location 7 is defined in Table 3-1, above.
Version Request (V)
The “V” command requests the firmware part number and version.
Request:
1 2 3 4 5
V *
*BCC is ignored in this command, even if enabled.
Returns the MT-85’s firmware version.
Response:
1 2 3 – 10 11 -13 14 15
V [Part Num] [Revision] {BCC}
[Part Num] is 8 decimal digits. [Revision] is a single letter (the major revision) followed by two
decimal digits (the minor revision). For Example: V15033401F01{BCC}