Teledex B-Series - Manual (Page 58)

CAUTION: If you do not have any special phone services, such as call waiting, etc., pressing the
FLASH/LINK key may disconnect the current call.
You can program the FLASH/LINK timing to suit your PBX requirements. Timings
available are: 0.1s / 0.2s / 0.3s / 0.4s / 0.5s / 0.6s / 0.7s / 0.8s / 0.9s / 1s. The timing is
preset to 0.6s. Follow these steps to reprogram the Flash/Link timing:
1) Press PRGM. PROGRAM MODE appears on the display.
2) Press FLASH/LINK . SET LINK TIME appears on the display for two (2) seconds,
then LINK TIME 0.6 S appears.
3) Press REVIEW or REVIEW to the desired link time.
4) Press PRGM to confirm the setting.
5) The phone beeps and the set time display returns.
NOTE: To reset the FLASH/LINK timing, or if you made a mistake, repeat the above steps.
11.10 USING HOLD
To place a call on hold, press the HOLD key. The LINE 1 or LINE 2 indicator will flash,
then the text message CALL ON HOLD will appear on the LCD. You can now hang up
the handset without disconnecting the call.
To resume the call, press the appropriate line key, or pick up the handset, or pick up
any extension phone on the same line. If you put a call on hold while using the
speakerphone, press the appropriate line key to resume the call.
11.11 USING MUTE
To temporarily switch off the microphone of either the speakerphone or handset,
press the MUTE key. The MUTE indicator lights and the microphone will turn off, but
you can still hear the person on the other end of the phone. Press MUTE again to
resume your conversation. Pressing the MUTE key while the handset is on-hook and
the phone is off-line will enter a one second pause into a number string.
11.12 MEMORY DIALING
You can store up to ten (10) phone numbers and names in the direct memory locations,
then quickly and conveniently call a number you have stored. These memory buttons
may also be used to store number strings used to access PBX or Centrex services or
features.
11.13 STORING A NUMBER IN MEMORY
Follow these steps to store numbers in the memory locations. Each memory location
can store up to sixteen (16) digits.
1) Press PRGM . The PROGRAM MODE prompt will appear.
2) Select the memory location where you want to store the number.
ENTER NUMBER will appear in the display.
3) Enter the phone number or number string you wish to store. If you enter
a digit by mistake, press DELETE to delete the last number entered.
Pressing DELETE once will delete the last digit, pressing twice will delete
the prior digit, etc.
4) When you are done entering the desired number, press the PRGM key.
5) The display will now read ENTER NAME . Press the letters on the keypad
corresponding to A through Z . (Please refer to the Keypad Legend on page 9 for
assistance.) To enter a space between letters, press the “1” key.
If you enter a letter by mistake, press the DELETE key. Pressing once will
delete the last letter, pressing twice will delete the prior letter, etc.
6) Once the correct letters are entered, press the PRGM key. You will hear
a long beep, and the display will show NUMBER STORED to confirm
your entry. The current time display will return.
NOTE: You will hear a dial tone during most steps of this procedure. The phone does not
7
Teledex B250D Users Manual
OPERATION
Contents Copyright © 2003 Teledex LLC