Teledex Diamond Series - Manual (Page 5)

DIAMOND SERIES USER GUIDE www.teledex.com 5
These telephone devices are intended for
commercial use only, primarily in hotel guestrooms.
They must be used with a PBX (private branch
exchange), and are not intended to be connected
directly to a PSTN line (public switched telephone
network). There are no user-serviceable parts
inside the equipment.
Care and Maintenance
• Keep the telephone dry. If it gets wet, wipe it
dry immediately. Liquids might contain minerals
that can corrode the electronic circuits.
• Use and store the telephone in a normal
temperature environment. Temperature
extremes can shorten the life of electronic
devices and distort or melt parts.
• Keep the telephone away from excessive
dust and dirt which can cause premature
wear of parts.
• Wipe the telephone with a damp cloth
occasionally to keep it looking new. Do not use
harsh chemicals, cleaning solvents, or strong
detergents to clean the system.
Technical Specifications
This guide covers product made from 2009
forward with a serial number beginning with XX.
For all other models please refer to the Teledex
website for legacy product documentation.
DIMENSIONS
6.25” (w) x 9.5” (l) x 3.75” (h)
WEIGHT
With handset: 1.85 lbs.
User Guides
If additional User Guides are needed, please go
to www.teledex.com to download the PDF.
Service
When problems arise that cannot be resolved
using this or related documents, please go to
www.teledex.com/support for information about
customer support, technical support, warranty,
and product returns.
Statement of Limited Warranty
Teledex product warranty information is available
at www.teledex.com.
Converting from Desk to Wall
Mount
The Diamond Series phone can be converted for
wall mounting applications. The conversion is
easiest when the handset and line cords are not
connected.
1. Located on the top of the telephone above
the speaker grill is the wall/desk mount
clip. Remove this clip by firmly pushing
upward (towards the hookswitch).
2. Flip the clip over (top to bottom) so that
the protruding edge is towards the top of
the phone, and reinsert into cutout. This
protruding edge will hold the handset.
3. Turn the telephone over so the bottom is
up, facing you. Place the telephone on a
non-abrasive surface to prevent scratching.
4. Locate and remove the mounting bracket,
firmly push back and pull up to remove two
of the four retaining tabs.
5. Rotate the mounting bracket 180 degrees
clockwise so that the mounting eyelet on
the bracket is facing in the same direction
as the other mounting eyelet located on
the bottom of the telephone.
6. Insert the top two retaining tabs of the
mounting brackets into the mounting
bracket slots (located near the middle of
the telephone). Then firmly push down to
insert the retaining tabs on the opposite
side of the mounting bracket.
7. Connect a short modular line cord into the
jack on the back of the phone (labeled LINE).
Route the line cord through the line cord
channel. Connect the other end of line cord
to the phone jack on the wall mounting plate.
8. Turn the telephone over, and slide the
telephone down onto the mounting posts
in downward direction. Both eyelets should
line up with the mounting posts.
9. Complete the wall mounting by installing
the handset and handset cord.