Teledex Diamond Series - Manual (Page 11)

DIAMOND SERIES USER GUIDE www.teledex.com 11
Unpacking Your Telephone
This package should contain the following:
• Telephone base unit
• Handset
• Coiled handset cord
• 1 straight line cord
Optional items to be ordered separately:
• Wall mount adaptor bracket
• Short line cord for wall mounting
Installation
CAUTION INFORMATION
• Never install telephone or network wiring
during a lightning storm.
• Never install telephone or Ethernet jacks in
wet locations unless the jack is specifically
designed for wet locations.
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying
telephone and network lines.
CONNECTING THE HANDSET CORD
A 10 ft. modular handset coil cord is provided.
To install, simply plug one end of the coil cord
into the jack at the base of the handset, and the
other end into the jack located on the end of the
telephone base marked Handset.
CONNECTING THE LINE CORD
A 15 ft. modular line cord is provided. To install,
simply plug one end of the cord into the modular
jack at the top end of the base unit and the other
end into the wall jack.
Features
1. Speed-Dial Memory Keys: 5,10, or 0 user-
programmable speed-dial keys with 32 digit
capacity. [Flash] and [Pause] are storable.
Speed-dial memory is non-volatile RAM, so
programming is retained without the need
for batteries or telephone line power.
2. Line 1 Key: Press Line 1 to place a call to
a party on Line 1. Place the call on hold if
you want to initiate a call on Line 2.
3. Line 2 Key: Press Line 2 to place a call to
a party on Line 2. Place the call on hold if
you want to initiate a call on Line 1.
4. CONF (Conference) Key: The Conf
key allows three-way conversations.
Depending on the situation, you may
initiate a conference call using one of
these methods:
CASE A—USER INITIATES TWO CALLS
1. Place your call to the first party, then put
them on hold by pressing the Hold key.
2. Using the second line (Line 2), place your
call to the second party, then place them
on hold by pressing the
Hold key.
3. Activate the conference by joining the calls
together when you press the Conf key.
CASE B—USER RECEIVES A CALL AND
PLACES A SECOND CALL
1. Receive a call from the first party then put
them on hold by pressing the Hold key.
2. Using the second line (Line 2), place call to
second party, then place them on hold by
pressing the
Hold key.
3. Activate the conference joining the calls
together by pressing the Conf key.
CASE C—USER RECEIVES A CALL AND THEN
RECEIVES A SECOND CALL
1. Receive the call from the first party and
put them on hold by pressing the Hold key.
2. Using the second line (Line 2), place your
call to the second party, then put them on
hold by pressing the
Hold key.
3. Activate the conference call by pressing the
Conf key which will join the calls together.
DIAMOND SERIES 2-LINE CORDED PHONES