Kenwood TK-90 - Manual (Page 18)

14
2 Press the CH and keys to select CODE A to
CODE D.
• Press the D> key to view the character message of
the selected code, and the key to return to the
code selection.
MANUAL STATUS CALLS
You can send and receive 2-digit Status codes which
may be decided in your talk group. Codes can
contain up to 12 alphanumeric character messages.
Status codes range from 10 to 99 (80 ~ 99 are
reserved for special messages).
M
AKING A
S
TATUS
C
ALL USING THE
T
RANSCEIVER
K
EYS
1 While in Selcall Mode, press the key programmed
as Selcall to view the Selcall list.
4 Press the CH and keys to select the status
you want to transmit.
5 Press the ■ key or the PTT switch to send the
status call.
• While making the call, the icon flashes and
“SEND DATA” appears on the display.
• “COMPLETE” appears on the display when the call
has been successfully transmitted.
• If the call cannot go through, “NO REPLY” appears
on the display.
M
AKING A
S
TATUS
C
ALL USING A
M
ICROPHONE
K
EYPAD
1 While in Selcall Mode, press and hold the PTT
switch, then enter the 3-digit ID of the station you
want to call.
2 While continuing to hold the PTT switch, press the
key to enter Status entry mode.
3 While continuing to hold the PTT switch, enter the
2-digit ID number of the status you want to
transmit.
4 While continuing to hold the PTT switch, press the
# key to send the status call.
• Releasing the PTT switch before entering the # key
will cancel the call.
• While making the call, the icon flashes and
“SEND DATA” appears on the display.
• “COMPLETE” appears on the display when the call
has been successfully transmitted.
• If the call cannot go through, “NO REPLY” appears
on the display.
3 Press the ■ key or the PTT switch to send the
message.
• While making the call, the icon flashes.
4 When the call connects, the LED indicator flashes
orange. Begin your conversation by pressing the
PTT switch and speaking into the microphone.
• A proceed tone sounds and the icon remains on
the display.
5 After you have finished your call, release the PTT
switch.
• Depending on the Auto Reset time set up by your
dealer, your speaker will mute if no reponse is
received. You can unmute the speaker to remain in
standby mode by pressing the key programmed as
Monitor.
S
ELECTING A
M
EMORY
C
ALL USING A
M
ICROPHONE
K
EYPAD
1 While in Selcall Mode, press and hold the PTT
switch, then enter the # key, key A to D (to select
the respective memory location), followed by the #
key again
• Releasing the PTT switch before entering the final #
key will cancel the call.
• While making the call, the icon flashes.
2 When the call connects, the LED indicator flashes
orange. Begin your conversation by pressing the
PTT switch and speaking into the microphone.
• A proceed tone sounds and the icon remains on
the display.
3 After you have finished your call, release the PTT
switch.
• Depending on the Auto Reset time set up by your
dealer, your speaker will mute if no reponse is
received. You can unmute the speaker to remain in
standby mode by pressing the # key or the key
programmed as Monitor.
2 Press the CH and keys to select the ID of the
station you want to call.
3 Press the D> key to view the Status list.