Kenwood TS-590S - Manual (Page 25)

25
Question Answer
If using the sound functions in
comprehensive chipsets, try an
independent sound card or USB sound.
Adjust the ACC2 audio level in menus
66 and 67.
There is static in the audio
transmissions or audio
transmissions are faint. Where
should I check and adjust them?
Try changing the sound function driver
version.
I can hear the beeping and voice
guidance audio from the transceiver
on the nearby PC. Alternatively, I
want to be able to hear them, but
can't. Set using the "Mix beeps with external
audio device" in menu 68.
Can I set the PC to sleep mode
while I'm not using the host station?
When a fixed time has elapsed
without the host station being used,
the station PC screen turns OFF,
and responses to connection
requests from the station cannot be
made.
Recovery from sleep mode takes time.
During sleep mode recovery, responses
to the remote station cannot be returned
until there is a time out. Therefore, we
recommend you do not set the station to
sleep mode.
If there is a connection request from
the remote station while the host
station is not being used, a
message is displayed and
connections to the host station are
disabled. Is the OS energy save mode operating,
and has the power supply to the host
station HDD been disabled?
When the HDD power supply is turned
OFF, the HDD power supply is turned
ON to respond, but at this time nothing
can be returned until the response to
the remote station has timed out.
Consequently, set the OS power supply
function settings so that the HDD power
supply does not turn OFF.
Audio I/O between the host station
PC and transceiver cannot be
performed correctly. Check that an existing device is
specified as the device connected to the
TS-590S using the host station PC
sound settings.
Operations
Modulation is not performed even
when the ARCP-590 "SEND" button
is pressed. Check that the same path as the
modulation path wired between the
transceiver and the PC has been
selected using the ARCP-590 "Transmit
control settings".