Kenwood TS-590S - Manual (Page 17)

17
4.5. Setting Broadband Routers
If implementing KNS operations via the internet, it is necessary to set the broadband
router connected to the host station.
Make the settings to transmit control data signals transmitted via the internet from the
broadband router to the host station PC.
This setting depends on the call method of the broadband router manufacturer, and may
be "Port forwarding", "IP masquerade", "Port conversion", "NAT address conversion", etc.
Refer to the user manual for the broadband router used.
The settings are described below.
Item (Example) Setting Details
Open IP address IP address of the PC used in the host station
Protocol TCP
Port Number 50000 (default value)
Direction Two-way
Caution:
¾ For the broadband router settings, refer to the broadband router user manual.
¾ Incorrect broadband router settings may stop the network or enable illegal external
access to the network. Take thorough precautions when changing the settings.
¾ Kenwood does not offer support for customer computers and networks.