Kenwood TS-480SAT - Manual (Page 23)

15
3 GETTING ACQUAINTED
q MIC connector
Connect a cable from the supplied microphone to this
connector {page 6}.
w PANEL connector
Connect a cable from the Remote Control panel to
this connector {page 6}.
e EXT.SP jack
Mate with a 3.5 mm (1/8"), 2-conductor (mono) plug
for connecting an external speaker {page 7}.
r DATA connector
Mates with a 6-pin male DIN connector for connecting
various accessory equipment, such as an external
TNC/ MCP or a RTTY terminal {pages 77, 78}.
t REMOTE connector
Mates with a 6-pin male mini DIN connector for
connecting an HF/ 50 MHz linear amplifier {page 77}.
y COM connector
Mates with a DB-9 female connector for connecting a
computer via one of its serial communication (COM)
ports {page 67}. Also used with the Quick Data
Transfer function {pages 66, 76} and DX
PacketCluster Tune function {pages 72, 79}.
u PADDLE and KEY jacks
The PADDLE jack mates with a 6.3 mm (1/4")
3-conductor plug for connecting a keyer paddle to the
internal electronic keyer. The KEY jack mates with a
3.5 mm (1/8") 2-conductor plug for connecting an
external key for CW operation. Refer to “Keys for
CW (PANEL and KEY)” {page 7} before using these
jacks.
i Plastic cover
If the EXT.SP jack, DATA connector and REMOTE
connector are not used, attach this cover to protect
the connectors from dust.
TX/ RX UNIT
MIC PANEL
PADDLE KEY
EXT.SP DATA REMOTE
COM
q w e r t y
u
i