Kenwood KRF-V6300D-S - Manual (Page 33)

English
33
DVD 6-channel analog input
Surround play is possible if you use a DVD player with 6- (5.1-)
channel output.
INPUT SELECTOR
INPUT MODE
DVD/6CH
Preparations
• Connect your DVD player to the DVD/6CH INPUT
jacks of this unit.
• Turn on all other components that will be used.
• Complete .
œ Select "DVD/6CH" as the input source.
∑ Press [INPUT MODE] to select "6CH INPT".
é Start playback of a DVD disc.
• It is not possible to adjust the speaker level or sound effect of the
channels separately when this unit is in the 6CH INPUT mode.
([SETUP], [SOUND], [LISTEN MODE], [ACTIVE EQ] and [TONE] will
not be functional.) Adjust the speaker level with the controls
of the DVD player. Refer to the Instruction manual of the DVD
players for the detailed operating instructions.
• Depending on the type of the signal or speaker setting, some
listen modes cannot be selected.
• When playback is started, the sound may be cut or interrupted
before the input source is confirmed as Dolby Digital.
• To enjoy Dolby Digital surround (as well as all the other listen
modes) from a single component, be sure to use a Dolby Digital
compatible source component.
• Dolby Digital or DTS signal having more channels than the
maximum number of playback channels available using this unit’s
current settings is input, downmixing is performed to match the
number of available channels.
• Some Dolby Digital Surround EX compliant discs do not contain
identification signals. For this reason, the receiver may not detect
these discs as Dolby Digital EX when the input mode is set to "F-
AUTO". In this case, set the listen mode to "DOLBY DIGITAL EX".
B60-5772-00_00_EN.indd 33 B60-5772-00_00_EN.indd 33 08.7.24 1:29:42 PM 08.7.24 1:29:42 PM