Kenwood KRF-V6300D-S - Manual (Page 25)

English
25
Crossover ("CROSS OVER")
The crossover frequency is the lower limit of the bass frequencies
reproduced from the speakers set to "NML" in the Setup>. The frequencies below the set crossover frequency
are output from other speakers (those set to "LRG" and the
subwoofer).
œ See ( ™) and
select "CROSS OVER".
∑ Use [MULTI CONTROL ∞/5] to select crossover
frequency.
The frequency is selected from 40, 60, 80, 100, 120, 150
and 200Hz.
é Press [SETUP].
® Go to the next setting, "LFE LVL".
If you wish to exit the setup mode, see setup mode>
™.
Low frequency effects level
("LFE LVL")
Low frequency effect signal is used exclusively for giving the field
effect of bass tone in the Dolby Digital and DTS signal.
œ See ( ™) and
select "LFE LVL".
∑ Use [MULTI CONTROL ∞/5] to adjust the low
frequency effect level.
The level is adjusted from 0dB to -10dB in 1dB step
decrements.
é Press [SETUP].
® Go to the next setting, "AUDIO DELAY".
If you wish to exit the setup mode, see setup mode>
™.
Audio Delay (Lip Sync)
("AUDIO DELAY")
If the monitored video is delayed in time with respect to the
audio from the speakers, the audio output timing can be delayed.
œ See ( ™) and
select "AUDIO DELAY".
∑ Use [MULTI CONTROL ∞/5] to adjust the delay
time.
The delay time is adjusted from 0ms to 300ms in 10ms
step.
é Press [SETUP].
The setup is complete when the "EXIT" indication
appears.
® Press [SETUP] to exit the setup mode.
B60-5772-00_00_EN.indd 25 B60-5772-00_00_EN.indd 25 08.7.24 1:29:34 PM 08.7.24 1:29:34 PM