Kenwood NX-320E3 - Manual (Page 11)

2
1 Match the guides of the
battery pack with the grooves
on the upper rear of the
transceiver, then firmly press
the battery pack in place.
2 Lock the safety catch to
prevent accidentally releasing
the battery pack.
3 To remove the battery pack,
lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.
Note:
◆
For battery pack charging procedures and useage, refer to the
battery charger Instruction Manual.
◆ The battery pack is not charged at the factory; charge it before
use.
◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is firmly closed.
INSTALLING/ REMOVING ALKALINE BATTERIES (OPTIONAL
BATTERY CASE)
◆ Do not install batteries in a hazardous environment where
sparks could cause an explosion.
◆ Never discard batteries in fire; extremely high temperatures can
cause batteries to explode.
◆ Do not short circuit the battery case terminals.
◆ Do not use rechargeable batteries.
PREPARATION
INSTALLING/ REMOVING THE (OPTIONAL) BATTERY PACK
1
3
2