Kenwood CMOS-200 - Manual (Page 9)

English | 9
To adjust the item:
After selecting the item, press the + or – button
to adjust it and press the view button to enter the
adjusted value.
6 End the setting.
Overhead View Image Adjustment
(Centering)
This item adjusts the center of the camera installation
position.
1 Select “OVERHEAD VIEW IMAGE ADJUSTMENT
(CENTERING)”.
2 Press the + or – button of the switch unit so
that the two white lines appear on the position
corresponding to the center line of the vehicle.
Adjustment is possible by one step to the left
and right. If the adjustment is not possible in the
currently available range, change the camera
position before retry.
• Select [Back] to go back to the previous
adjustment item.
• Select [Next] to advance to the next adjustment
item.
• Selecting [Reset] in an individual adjustment
item resets the camera setting of that item to the
default.
• Select [ ] to invert the icon upside down.
3 After completing the adjustment, press the
view button.
Advances to “OVERHEAD VIEW IMAGE
ADJUSTMENT (Right-and-Left ANGLE)”.
Overhead View Image Adjustment
(Right-and-Left Angle)
This item adjusts the horizontal angle (in the rotary
direction) of the camera installation position.
1 Select “OVERHEAD VIEW IMAGE ADJUSTMENT
(Right-and-Left ANGLE)”.
2 Press the + or – button of the switch unit so that
the center of the parking space is displayed
vertically.
Adjustment is possible by one step to the left
and right. If the adjustment is not possible in the
currently available range, change the camera
position before retrying.
3 After completing the adjustment, press the
view button.
Advances to “OVERHEAD VIEW IMAGE
ADJUSTMENT (Up-and-Down ANGLE)”.
$AKPFD