Kenwood TK-8302E - Manual (Page 10)

5
BASIC OPERATIONS
S
witching
p
ower
on/ oFF
Press to switch the transceiver ON.
• A beep sounds and the display illuminates.
• If the Transceiver Password function is programmed, “PS” will appear on the display
when the power is turned ON. Refer to “Transceiver Password”, below.
Press again to switch the transceiver OFF.
n Transceiver Password
To enter the password:
1 Press / to select a digit.
• When using a keypad, simply enter the password digits and proceed to step 3.
2 Press C> to accept the entered digit and move to the next digit.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
• Repeat steps and 2 to enter the entire password.
3 Press S or to confirm the password.
• If you enter an incorrect password, the transceiver remains locked.
A
djuSting the
V
olume
Press the Volume Up key to increase the volume. Press the Volume Down key
to decrease the volume.
If Squelch Off has been programmed onto a key, you can use that function to
listen to background noise while adjusting the volume level.
S
electing A
Z
one And
c
hAnnel
Select the desired zone and channel using the keys programmed as Zone Up/
Zone Down and Channel Up/ Channel Down.
• “G” (Zone ) appears on the display.
t
rAnSmitting
/ r
eceiVing
1 Select your desired zone and channel.
• In Voting and Voting with Signaling zones, the channel is selected automatically.
2 Press microphone PTT switch and speak into the microphone to transmit.
Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately
.5 inches (3 ~ 4 cm) from your mouth.