Kenwood M-616DV-W - Manual (Page 5)

English
5
Preparing the remote control unit
When you use the remote control unit for the first
time, pull out the insulation sheet.
Operation
When the power cord is plugged in, STANDBY/TIMER
indicator is lit. The power turns ON by pressing
button on the remote control unit pointing at the
remote sensor. When the power comes on, press the
button you want to operate.
Approx. 6 m
30° 30°
Remote sensor
⁄
• The supplied battery may have shorter live than ordinary
battery due to use during operation checks.
• When the remote-controllable distance gets shorter than
before, replace the battery with a new one.
• Placing the remote sensor in direct sunlight, or in direct
light from a high frequency fluorescent lamp may cause a
malfunction.
In such a case, change the location of the system installation
to prevent malfunction.
¤ CAUTION
• Lithium battery.
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be exposed to
excessive heat such sunshine, fire or the like.
• Keep battery out of reach of children and in original
package until ready to use. Dispose of used batteries
promptly. If swallowed contact physician immediately.
Changing the battery of the remote control
unit
Use a commercially available button battery
(CR2025).
⁄
• Insert the battery into the remote control unit by matching
the polarities (+ and –) correctly.
How to read this manual
Most of the functions are designed to be able to
operate from the remote control unit.
CR2025 (+side)
M616DV_12th.indd 5 M616DV_12th.indd 5 11.7.6 0:05:29 PM 11.7.6 0:05:29 PM