Installing the antenna – Kenwood KTC-V301E User Manual

Page 6

KTC-V301E

Installing the Antenna

■ Installation Procedure

Ceramic line

Cable connector

Viewed from inside the vehicle

Slit

Film antenna
(Accessory 1)

Release paper 1

Film antenna

Slit

Confirm the installation place.

• Affix the film antennas and cable

connectors to the front windshield
following the laws and regulations of
your country.

• Affix each film antenna so that it does

not overlap the ceramic line. Affixing
the antenna on the ceramic line will
lose the adhesion force.

Using the cleaner (Accessory

0), wipe dirt off the antenna
installation surface.

Affix each film antenna.

1) Peel off the release paper (half-

transparent sheet) 1 starting at the
slit, and then affix the film antenna to
the windshield.

• Once peeled off, the remaining

portions of the antenna cannot be
affixed again. Confirm the installation
place again.

2) Peel off the release paper 2 starting

at either slit, and affix the film antenna
to the windshield.

3) Peel off the release paper 3 and

release paper 4 and affix the film
antenna to the windshield in the
same manner as above.

• Either the left or right side of the film

antenna can be affixed first.

• Inserting the release paper 1 under

the corner of the film antenna as
shown on the right allows you to peel
off other sheets of release paper easily.

B64-4243-00_KTC-V301E.indb 6

08.7.29 10:30:51 AM