Kenwood KTC-V301E - Manual (Page 2)

2 | KTC-V301E
Before installation
• If the ambient temperature is low, warm the glass
before starting the work.
• Before starting the work, confirm well the places
where the film antennas (Accessory 1 and 2) and
the cables (Accessory 3 and 4) are to be installed.
Once peeled off, the film antennas and double-stick
tape lose adhesion.
• Do not fold or damage the film antennas.
• Noise generated by the air conditioner or monitor
can cause poor TV reception.
• The film antennas cannot be installed depending on
the vehicle model.
• The reception sensitivity can vary with the
windshield wiper operation depending on the
vehicle model.
• The reception sensitivity can vary depending on the
relationship between the traveling direction of the
vehicle (the pointing direction of the antennas) and
the location of the broadcast station.
Connectable Control unit
• DNX8220BT
• DNX7220
• DNX5220BT
• DNX5220
• DDX8022BT, DDX8022BTY
• DDX5022, DDX5022Y
• DDX52RT
• KVT-522DVD, KVT-522DVDY
• KVT-50DVDRY
(As of July, 2008)
Before installing the antenna
2WARNING
• Mounting and wiring this product requires skills and
experience. For safety's sake, leave the mounting
and wiring work to professionals.
2CAUTION
• In-car antennas have a lower reception sensitivity
than antennas intended for outside mounting. The
picture may not appear or may be disturbed if the
signal in your area is weak.
• The film antennas are designed specially for use in
car.
• Do not attach the film antennas in the following
places:
– A place where the driver’s view is blocked
– A place where safety parts such as an airbag are
prevented from operating normally
– On the surface of a glass such as a rear hatch glass
which is frequently moved
• The reception sensitivity lowers in the following
places:
– A place where a heat reflection glass or mirror-
type glass film is affixed
– A place where the film antenna of the factory-
supplied radio already exists
– On the window where the heating wire already
exists
– On the side of the vehicle (door, front quarter
window, etc.)
– On the rear window
– On a glass (heat reflecting glass, heat insulating
glass, etc.) that blocks radio waves
• Using the cleaner (Accessory 0), remove oil and dirt
from the glass surface to which the film antennas
are to be affixed.
B64-4243-00_KTC-V301E.indb 2 B64-4243-00_KTC-V301E.indb 2 08.7.29 10:30:49 AM 08.7.29 10:30:49 AM