beautypg.com

Installing the metal mesh grease filter, Close the filter cover, Press and hold the "-" button for two seconds – Siemens LC98KA671 User Manual

Page 14: Notes, For removing the metal grease filter, see above, For fitting the metal grease filter, see above, Trouble shooting, Risk of electric shock, Malfunction table, After-sales service

background image

14

Installing the metal mesh grease filter

1.

Insert the two metal grease filters under the filter cover with

the lock facing downwards.
Insert the metal grease filters on the underside of the

appliance.

2.

Fold the metal grease filters inwards, locking them in place.

3.

Close the filter cover.

4.

Press and hold the "-" button for two seconds.
The saturation display is reset.

Changing the activated charcoal filter (only in

circulating-air mode)

In order to guarantee efficient odour filtration, the filter must be

serviced regularly.
The activated charcoal filters must be replaced at least every

4 months.

Notes

The activated charcoal filters are not included in the delivery.

The activated charcoal filters can be obtained from specialist

retailers, from our after-sales service or from the Online Shop.

The activated charcoal filters cannot be cleaned or

reactivated.

1.

For removing the metal grease filter, see above.

2.

Turn the old activated charcoal filter and pull away from the

bracket.

¨

3.

Push the new activated charcoal filter onto the bracket and

turn.

©

4.

For fitting the metal grease filter, see above.

5.

Press and hold the "-" button for two seconds.
The saturation display is reset.

Trouble shooting

Malfunctions often have simple explanations. Please read the

following notes before calling the after-sales service.

:

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
LED lights
Defective LED lights must only be replaced by the

manufacturer, their customer service department or a licensed

technician (electrician).

Malfunction table

After-sales service

Our after-sales service is there for you if your appliance needs

to be repaired. We will always find the right solution in order to

avoid unnecessary visits from a service technician.
When calling us, please give the product number (E no.) and

the production number (FD no.) so that we can provide you with

the correct advice. The rating plate with these numbers can be

found inside the appliance (remove the metal mesh grease

filter to gain access).
You can make a note of the numbers of your appliance and the

telephone number of the after-sales service in the space below

to save time should it be required.

Please be aware that a visit by an after-sales engineer will be

charged if a problem turns out to be the result of operator error,

even during the warranty period.
Please find the contact data of all countries in the enclosed

customer service list.

%

$

Problem

Possible cause Solution

The appliance

does not work

The plug is not

plugged in.

Connect the appliance to

the electricity supply

Power cut

Check whether other

kitchen appliances are

working

Faulty fuse

Check in the fuse box to

make sure that the fuse for

the appliance is OK

The button

illumination

does not work.

The control unit

is faulty.

Call the after­sales service.

The lighting

does not work.

The bulbs are

faulty.

Call the after­sales service.

If

ª

or

appears on the

display

The grease or

activated

charcoal filter is

saturated.

Clean the filter – see

section "Cleaning and

maintenance".

E no.

FD no.

After-sales service

O