beautypg.com

Operating the appliance, Note, Control panel – Siemens LC98KA671 User Manual

Page 12: Setting the fan, Press the # button, Intensive setting, Press the › button, Fan run-on time, Press the x button, Press the x button again

background image

12

Operating the appliance

These instructions apply to several appliance variants. It is

possible that individual features are described which do not

apply to your appliance.

Note: Switch on the extractor hood when you start cooking and

switch it off again several minutes after you have finished

cooking. This is the most effective way of removing the kitchen

fumes.

Control panel

Setting the fan

Note: Always adjust the fan strength to meet current conditions.

If there is a large build-up of steam or fumes, select a high fan

setting.
Switching on the appliance

1.

Press the

#

button.

The fan starts at setting 1.

2.

Press the "+" or "-" buttons to set another fan setting.

Switching off the appliance
Press the

#

button.

Intensive setting

You can use the intensive setting if there is a large build-up of

odours and fumes/vapours.

1.

Press the

button while ventilation is switched on.

The intensive setting is activated.

2.

Press the

button.

The intensive setting is deactivated.

Note: The intensive setting run time is 10 minutes. Once this

time has elapsed, the appliance switches back to the fan

setting that was previously set.

Fan run-on time

1.

Press the

x

button.

The fan continues to run at this fan setting for 15 minutes and

then switches off automatically after this time. The current fan

setting and the remaining run-on time in minutes are

displayed alternately in the display panel. If the lighting is

switched on, this is also switched off after the run-on time.

2.

Press the

x

button again.

The fan run-on ends before the end of the remaining run-on

time.

Lighting

The lighting can be switched on and off independently of the

ventilation.
Press the

@

button.

Setting the brightness

1.

Press and hold the

@

button for two seconds.

The brightness is reduced.

2.

Press the

@

button.

The maximum brightness is restored.

Saturation display

When the metal grease filter or activated charcoal filter is

saturated, the corresponding symbol flashes:

Metal grease filter:

ª

Activated charcoal filter:

When this happens, do not delay cleaning the metal grease

filter or replacing the activated charcoal filter any further.
For instructions on how to clean the metal grease filter, please

refer to the section "Cleaning and maintenance".
Restoring the saturation displays

1.

Switch off the motor.

2.

Press and hold the "-" button for two seconds.

Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be

switched over accordingly:

1.

Check that the extractor hood is connected and switched off.

2.

Press and hold the "+" button for two seconds.

flashes twice, i.e. the electronic control is switched over to

circulating-air mode.

3.

Press the "+" button.

flashes once, i.e. the electronic control is switched back to

exhaust-air mode.

Explanation
1

Switch the fan on/off

2

Switch on the lighting

3

Turn the fan down

4

Display panel

5

Switch up the fan setting

6

Switch on intensive mode

7

Switch on fan run-on