Siemens LI44630 - Manual (Page 26)

26
3. Tighten the two fixing screws with a
screwdriver (cordless).
4. If required, shorten the wall cover to the
required dimension (e.g. saw off).
Attach the wall cover with the enclosed
clips.
Screw the wall cover to the wall
cupboard.
5. Feed the mains connection cable out of
the cupboard.
6. Connect the pipes in the wall cupboard.
– If required, attach the air hose to the
cupboard ceiling –.
7. Re-insert grease filter
(see Operating instructions).
Note: The extractor hood housing can be
clad inside the wall cupboard (e.g. with
chipboard).
If so, observe the following:
❑ The intermediate base must not be
placed on the extractor hood housing.
❑ Never attach cladding to the housing.
❑ Provide access for customer service.
Fitting into wall cupboard
ṇ
Check door alignment and readjust if
necessary.
1. Remove grease filter
(see Operating instructions).
2. Lift the extractor hood into the cupboard
from below until both fixing lugs have
locked firmly into position.
❑ Align the extractor hood in the
cupboard.
❑ Carefully tighten both fastening screws.
ṇ
Check that the extractor hood is
secure in the cupboard.