Kenwood TM-281A - Manual (Page 61)

54
11
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
The transceiver generates the following warning beeps
even if the Beep function is turned OFF.
• APO warning beeps {page 52}
• Time-out Timer warning beep {page 60}
Note: The beep output level is linked to the VOL control position.
BUSY CHANNEL LOCKOUT
This function is used to prevent transmitting on a
channel or frequency that somebody else is currently
using. When turned ON, an error beep sounds and
you cannot transmit even if you press Mic [PTT] while
another party is using the channel or frequency.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 22 (BCL).
2 Press [MENU] and turn the Tuning control to select
“ON” or “OFF” (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
FREQUENCY STEP SIZE
Choosing the correct frequency step size is essential in
selecting your exact receive frequency using the Tuning
control or Mic [UP]/[DWN]. You can select your desired
frequency step size from:
2.5 kHz (TM-281A Only), 5 kHz, 6.25 kHz, 10 kHz, 12.5
kHz, 15 kHz, 20 kHz, 25 kHz, 30 kHz, 50 kHz, 100 kHz.
To change the frequency step size:
1 While in VFO Mode, press [F], [MENU] and turn the
Tuning control to select Menu No. 1 (STP).
2 Press [MENU] and turn the Tuning control to select
your desired frequency step size.
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
Note: If you change to a frequency step size that does not match the
current operating frequency, the transceiver automatically adjusts the
frequency to match the new frequency step size.