Kenwood TM-281A - Manual (Page 43)

36
7
CHANNEL DISPLAY
While in this mode, the transceiver displays only Memory
Channel numbers (or Memory Names if they have been
stored), instead of frequencies.
1 With the transceiver power OFF, press [REV]+[ ]
(Power) to turn the power ON.
• The transceiver displays the Memory Channel numbers
in place of the operating frequencies.
2 Turn the Tuning control or press Mic [UP]/[DWN] to
select your desired Memory Channel number.
While in Channel Display mode, you cannot activate the
following functions:
• VFO Mode
• VFO Scan
• Call/VFO Scan
• MHz Scan
• Scan Direction
• Memory Store
• Memory to VFO Transfer
• Memory to Memory Transfer
• Clear Memory Channel
• VFO Reset
• Full Reset
• 1 MHz Step
• Selection for Tone and Selective Call
• Auto Simplex Checker
• Menu Mode
To recover normal operation, turn the transceiver power
OFF and press [REV]+[ ] (Power) again.
Note:
◆ To enter the Channel Display Mode, you must have at least one
Memory Channel that contains data.
◆ If the Memory Channel contains a Memory Name, the Memory
Name is displayed in place of “CH”.