Kenwood DNN991HD - Manual (Page 24)

24 ñ English
Ñ Connecting wires to terminals
POWER
PTT
EXT
I/F
SW
FRONT
REAR
AV-OUT
AUDIO
R L
FUSE 10A
GPS
AV-IN/OUT MIC
HDMI/MHL
iPod/
AV-IN2
M4 x 8mmMAX
iDalalink
I/F
+
+
+
+
A
A
REMOTE
CONT
ILLUMI
MUTE
ANT CONT
P. CONT
STEERING
WHEEL
REMOTE
INPUT
Red (Ignition wire)
Black (Ground wire) ¤
(To car chassis)
Yellow (Battery wire)
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matched to your car.
Light Blue/Yellow
(Steering remote control wire)
Orange/White (Dimmer
control wire)
Brown (Mute control wire)
Blue
(Antenna control wire)
Blue/White
(Power control wire)
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To use the Mute feature, you need to hook
up this wire to your telephone by using a
commercial telephone accessory.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier
of the film-type antenna. (Max. 300mA, 12V)
When using the optional power amplifier,
connect to its power control terminal.
If no connections are made,
do not let the cable come out from the tab.
To steering remote
To car light control switch
Ignition key
switch
Car fuse box
(Main fuse) Car fuse box
ACC
Battery
Accessory 1
White/Black
Gray/Black
Green/Black
Purple/Black
Speaker impedance: 4-8 Ω
Purple
Green
Gray
White
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker