Kenwood DNX691HD - Manual (Page 107)

106 106
Return to the Top page
Setting Up
AV Output Interface Setup
You can select an AV source to be output at
the AV OUTPUT port. Default is “VIDEO1”.
1
Touch [Menu] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [AV-OUT].
AV-OUT Interface screen appears.
4
Touch [ 2] or [3] to set [AV-OUT] to
VIDEO1, DISC, iPod, USB, or OFF.
NOTE
• Only when iPod is connected to this unit with
KCA-iP202, “USB” can be selected as AV output
source. For the connection setting, refer to
iPod/
iPhone connection setup (P.56) .
External Device Control
(DNX891HD, DNX7710BT only)
Control the external device power supply.
1
Touch [EXT SW] in the Source Control
screen.
EXT SW Control screen appears.
NOTE
• If [EXT SW] is not displayed, touch [ ].
2
Touch the desired switch key.
You can turn on or off the external device
power supply.
NOTE
• You must connect a commercially available relay
unit in order to use this function. Connect the
external device to be controlled to that relay unit.
• See EXT SW setup (P.98) for information on
setting the power on or off specification.