Kenwood TK-2360/3360 - Manual (Page 11)

Note:
◆
if you do not plan to use the transceiver for a long period,
remove the batteries from the battery case .
◆
this battery case has been designed for transmitting at a
power of approximately 1 W (the low power setting on your
transceiver). If you want to transmit a stronger signal (using
the high power setting on your transceiver), use an optional
rechargeable battery pack .
1 to open the battery case, press
on the two tabs on the upper
rear of the case, then pull the
two halvs apart.
2 insert 6 aa (lr6) alkaline
batteries into the battery case .
• be sure to match the polarities
with those marked in the bottom
of the battery case .
3 Align the tabs of the cover with
the base, then push down on
the cover until it locks in place .
INSTAllING THE (OPTIONAl) ANTENNA
Screw the antenna into the
connector on the top of the
transceiver by holding the antenna
at its base and turning
it clockwise until secure.